Production

Production Process

Our colloidal silver is produced using a custom Biophysica generator in a proprietary configuration utilizing very large area 99.99% pure silver plates at the lowest current in the purest water. We use strict ambient light and temperature controls to insure the highest concentration of 1-5nm silver nanoparticles. This low current, low temperature process allows us to produce strong 25ppm colloidal silver with a high Zeta potential electrical charge without using any electrolyte salt additives to compromise quality.

The charged ionic silver nanoparticle (AG+) production is partially reduced to its colloidal state (AG) using mild heat and one drop per liter of filtered organic agave syrup, which provides the needed electrons for reduction. We filter the final colloidal silver using a Buchner vacuum .22um filter to insure only the safest, most effective nanoparticles remain. Our resulting colloidal silver is very effective and stable, with a high Zeta potential and exceptional surface area.

Structured Water

The final stage of our 6-stage water filtration process uses sequential reverse osmosis filters and the finished filtered pure water is then processed using an UMF water structuring device. The Biophysica generator we use also provides specific frequencies that modulate the production current to provide additional water structuring. Structuring adds additional energy to the water that may provide additional effectiveness to our colloidal silver. Our whole production process is optimized to encourage water structuring, a relatively new science whose benefits are not yet fully understood but believed to add important, healthful characteristics to water.